Safety valve, preset and lead-sealed, G 1/2", DN 10, 0.50 bar, nickel-plated brass

From 0.50 bar upwards this safety valve opens by itself and releases up to 38.2 m³/h of gas to the surrounding air. Once the pressure has dropped it closes again without any intervention. Installation uses the G 1/2" thread, nominal size DN 10 and a body made of nickel-plated brass.

Benefits

• Screwed in through G 1/2" in DN 10 and tightened at the 27 mm wrench flat.
• Valve body in nickel-plated brass, matching compressed air and non-toxic, non-flammable gases.
• Type-approved and marked with the component identification TÜV.SV...-882.10.D/G.0.35 CE0036 0,5 bar.
• The set value of 0.50 bar stays traceable and unchanged thanks to the lead seal.
• Discharge capacity of 38.2 m³/h, referred to the set pressure of 0.50 bar.

Technical data

Applications

• Protection of pipes and fittings in compressed air networks with a G 1/2" connection.
• Use on compressors and air treatment units where up to 38.2 m³/h have to be discharged.
• Protection of gas lines carrying non-toxic, non-flammable gases up to 0.50 bar.

Standards and conformity

The component identification TÜV.SV...-882.10.D/G.0.35 CE0036 0,5 bar proves the type approval and states the notified body CE0036 together with the set pressure. Valves of this series are delivered with fixed settings between 0.2 and 50 bar, here at 0.50 bar. An NPT thread and a setting certificate are available as options.