Male stud tee fittings
Tube fittings
Male stud tee fittings split a hose line at a tapped port: the stud sits in the thread, two aligned hose legs run across it. This range covers 63 items, all of plastic construction.
Selection follows the stud thread from G 1/8" up to G 1/2", the hose size from 6x4 to 14x12 mm (outside by inside diameter), then the polymer: polyamide for general compressed air, polypropylene as well as PVDF for chemically loaded media. Every size uses connection principle 1, while the pipe thread seals towards the port.
These tees serve wherever a consumer is tapped straight off the machine, at cylinder end caps, valve blocks, measuring points. Polypropylene versions along with PVDF versions suit water lines, cleaning lines, chemical lines that would attack metal fittings. Sizes from 12x10 mm upwards feed two legs from a single supply line, so no separate manifold is needed.
