Sensor Accessories: Connectors, Cables, Brackets
Measurement, Monitoring and Leak Detection
A sensor or a valve is incomplete without its electrical interface. This category holds 36 items from Riegler that close exactly that gap: solenoid coils for solenoid valves and connectors for wiring them. Coils are available for directly operated valves with G 1/8 and G 1/4 as well as for forced pilot operated valves in DN 13, so a faulty coil can be replaced without taking the valve out of the pipe.
The voltage series covers 12 V DC, 24 V DC, 24 V AC, 110 V AC and 230 V AC, with power draw from 5.5 W to 33 W on DC and 8.5 VA to 20 VA on AC. Valves can therefore be run on extra-low voltage just as well as on mains. The form A connector with LED and M16 female thread works from 200 to 240 V, AC and DC alike, and shows at the valve itself whether the coil is energised.
Coils and connection technology at a glance
| Version | Valve type | Voltages | Power draw |
|---|---|---|---|
| Solenoid coil, directly operated | G 1/8 | 24 V AC, 110 V AC, 12 V DC | 8.5 to 9 VA, 5.5 W |
| Solenoid coil, directly operated, pilot assisted | G 1/4 | 24 V AC, 110 V AC, 230 V AC, 12 V DC, 24 V DC | 17.6 VA, 15 W |
| Solenoid coil, forced pilot operated | DN 13 | 24 V AC, 110 V AC, 230 V AC, 12 V DC, 24 V DC | 17.6 to 20 VA, 18.5 to 33 W |
| Form A connector | coil connection | 200 to 240 V AC and DC | LED indication, M16 female thread |
- replacement coils for solenoid valves in make-up and shut-off duties
- converting a valve from mains supply to 24 V extra-low voltage
- wiring valves and sensors with voltage indication at the device itself
- repair during operation without draining the cooling loop
- spare part stock for control cabinet and plant room
