Safety valve, TÜV type-tested, factory-set and lead-sealed, G 1/2", DN 8, 48.00 bar, brass

The set pressure of 48.00 bar is fixed and lead-sealed at the factory, so no readjustment is needed in service. At DN 8 the valve carries away up to 1170 m³/h and blows off freely. The body is made of brass and the connection thread is G 1/2".

Benefits

• Discharge capacity 1170 m³/h at nominal size DN 8.
• Connection thread G 1/2" with 24 mm across flats.
• Set pressure 48.00 bar, fixed and lead-sealed at the factory.
• Free blow-off of up to 1170 m³/h for compressed air and other non-toxic, non-flammable gases.
• Body of brass with an FKM seal for -25 to +180 °C.

Applications

Typical installation points are pressure vessels, compressor stations and pipe runs with a G 1/2" connection. Because the valve blows off freely, it is intended for compressed air and further non-toxic, non-flammable gases.

Standards and conformity

The valve is type-tested and carries the component marking TÜV.SV...-882.8.D/G.0.65 CE0036 48 bar. It is supplied exclusively with a fixed setting and a lead seal.