Corner safety valve, for compressed air and non-flammable gases, G 1-1/2", DN 22, 9.0 bar, gunmetal

Large compressed air receivers and headers call for protection with a sufficient discharge capacity. This corner valve with DN 22 and connection G 1-1/2" releases 789 m³/h at a set pressure of 9.0 bar. The body is made of gunmetal, the spring of spring steel and the seal of FKM. The permissible temperature range runs from -20 to +200 °C. The overall height is 140 mm and the face-to-centre length 46 mm.

Advantages

• Gunmetal body, spring steel spring and a seal of FKM, matched to compressed air and other non-toxic, non-flammable gases.
• Fixed set pressure of 9.0 bar, so the protection is unambiguous without any adjustment on site.
• Corner design with 46 mm face-to-centre length and 140 mm overall height, so the valve adds little to a vessel wall.
• Discharge capacity of 789 m³/h of compressed air at DN 22, sufficient for the matching receiver or compressor.
• Type tested and marked with the component identification TÜV-SV...-312.22.D/G.0,28 CE0036 9 bar, which simplifies the acceptance of the plant.

Applications

Pressure vessels in plant engineering with nominal size DN 22. Protection of headers with a discharge capacity of 789 m³/h. Test rigs and experimental setups limited to 9.0 bar. Installation in tight spaces where the corner design with 46 mm face-to-centre length saves room.

Standards and conformity

The valve is type tested and carries the component identification TÜV-SV...-312.22.D/G.0,28 CE0036 9 bar. It is supplied with a fixed setting only, so the set pressure of 9.0 bar cannot be altered. A setting certificate to 3.1 is available on request.