T-piece 130, 3 x Rp 1/4 IT, black malleable iron fitting - Riegler 133670

T-piece 130, 3 x Rp 1/4 IT, black malleable iron fitting, Operating temp. -20 °C to 300 °C, ISO 7-1 According to DIN EN 10242 (previously 2950). Malleable iron cast fittings in black steel, non-galvanized, is the classic fitting series in connection series in piping construction. Our malleable iron cast fittings are characterized by high mechanical strength and standardized fitting technology. Working minimal temperature = -20 °C, 25 bar. Working pressure for temperature range from -20 °C to 120 °C: 25 bar. Working pressure for temperature range from 120 °C to 300 °C: 20-25 bar.

Technical data

Standards and origin

• Standard thread: ISO 7-1
• Customs tariff number: 73071910
• Country of origin: CN

About Tees

A tee branches a pipe run at a right angle without extra elbows and nipples. The range covers Rp 1/4 through Rp 3, with threads to ISO 7-1. The material is black malleable cast iron B350-10 throughout.

What matters when choosing

• Thread 1 as the run size: available from Rp 1/4 to Rp 3 female. It follows the nominal size of the main line.
• Thread 2 for the branch: Rp 1/4 to Rp 2 1/2 female, plus versions with R 3/8, R 1/2 and R 1 male thread that save an additional nipple.
• Reducing version where the branch is to be smaller than the run. 29 of the 74 articles are built this way.
• Thread standard ISO 7-1: the seal is made on the thread itself, though a suitable sealing compound still belongs to the installation.
• Size step: with strongly reducing branches it is worth checking flow velocity in the smaller leg so that pressure loss stays acceptable.

Typical applications

• Branch points in compressed air ring mains in workshops and production halls.
• Distribution in heating and water installations built from threaded pipe.
• Connecting measuring points, vents and drains to existing pipe runs.
• Extending an existing line when a further machine is tied in.
• Industrial pipework where detachable threaded joints are required instead of welds.

Threads comply with ISO 7-1 and the fittings follow DIN EN 10242, with black malleable cast iron B350-10, design symbol A, as the material. Production is in China.