Straight reducing supports, for hose I.D. 8/6 mm, POM - Riegler 111002

Straight reducing supports, for hose I.D. 8/6 mm, working pressure max. 10 bar, temperature range -40 to 80 °C, POM Lightweight tube connectors distinguished by high strength, toughness, resistance to abrasion and impact resistance.

Standards and origin

• Customs tariff number: 39174000
• Country of origin: DE

About Hose connectors

Straight connectors join two hose ends in line, and as reducing versions they also bridge two different bores. The group covers hose I.D. 2 to 25 mm at a maximum working pressure of 10 bar. The barb is pushed into the hose and held with a clamp, so no thread is involved.

What matters when choosing

• Hose I.D. of 2 to 25 mm is the governing dimension and the axis of the configurators. It has to match the bore of the hose already installed.
• Same size or reducing: the reducing versions carry two figures, hose I.D. 1 and hose I.D. 2, and make the step between two hose bores in a single part.
• Material acetal copolymer (POM) or brass CW617N. POM is light, abrasion-resistant and impact-tough, while the brass parts are intended for PA and PUR hose.
• Max. working pressure of 10 bar applies to the whole group. Anything above that belongs on a screwed union rather than a barb and clamp.
• Min. and max. temperature: the POM versions are rated -40 to 80 °C. Cold outdoor locations and warm process air still fit, hot media do not.

Typical applications

• Extending compressed air hoses at machines and assembly stations
• Stepping between two hose bores in pilot lines
• Repairing damaged PA and PUR lines
• Low-pressure coolant and flushing lines
• Temporary routing on test and trial rigs

The materials used are acetal copolymer (POM) and brass CW617N. Manufacturing takes place in Germany and China.