Straight bulkhead fitting, Pipe exterior Ø 12 mm - Riegler 112446

Straight bulkhead fitting, Pipe exterior Ø 12 mm, PN max. 315 bar, Stainless steel 1.4571 Suitable for compressed air, liquids, natural gas and hydraulics. Not suitable for nitrogen, oxygen, helium, hydrogen or welding gases!

Technical data

Standards and origin

• Customs tariff number: 73072910
• Country of origin: DE

About Bulkhead connectors

A straight bulkhead fitting takes a pipe run through a wall, a panel or a tank plate and clamps the tube on both sides, so the opening itself carries no load. The group covers tube outside diameters from 6 to 28 mm at PN 160 to 630 bar.

What matters when choosing

• Tube O.D. 6 to 28 mm: the diameter follows the installed pipe. Both sides of the feed-through are the same size, so the line continues unchanged.
• PN 160 to 630 bar: the light version is rated at 315 bar, or 160 bar on the larger diameters, while the heavy version reaches 630 bar. The design pressure of the line decides.
• Material galvanised steel to DIN 2353 or stainless steel 1.4571: stainless is chosen where moisture or aggressive ambient air acts on the feed-through.
• Spanner sizes SW 1 to SW 3 and length L1 are listed per item. Both decide whether there is enough room behind the wall to get a spanner on.
• The wall thickness at the mounting point has to suit the length of the bulkhead thread so the lock nut seats properly.

Typical applications

• Taking hydraulic lines through tank and reservoir walls
• Pipe feed-throughs on machine housings and panelling
• A fixed separation point between power unit compartment and working area
• Frame feed-throughs in mobile hydraulics on construction and agricultural machinery
• Test rigs where a line has to be disconnected at a defined point

The 22 items are made of galvanised steel to DIN 2353 or stainless steel 1.4571 and are produced in Italy and Germany.