Safety valve, type-approved, preset and sealed, G 3/8", DN 10, 9.00 bar, brass

The valve keeps the pressure in compressed air and gas lines below 9.00 bar and works without auxiliary power. The tested discharge capacity of 404 m³/h matches the DN 10 nominal size. It is screwed in via G 3/8" and the body material is brass.

Benefits

• Connection thread G 3/8" at nominal size DN 10, installation with 27 mm across flats.
• FKM seal, which covers a temperature range from -25 to +180 °C.
• Overall height 95 mm and screw-in section height 12 mm, so the space required can be determined before installation.
• Body material brass, approved for compressed air and other non-toxic, non-flammable gases.
• Type-tested design carrying the component marking TÜV.SV...-882.10.D/G.0.71 CE0036 9 bar.

Applications

• Control air circuits that are protected against pressure peaks.
• Manifolds and receivers with a G 3/8" connection.
• Installations with requirements on the resistance of the material brass.

Standards and conformity

The valve is type-tested and carries the component marking TÜV.SV...-882.10.D/G.0.71 CE0036 9 bar. Only the factory set and lead-sealed version is supplied, the set value of this article is 9.00 bar. Fixed settings between 0.2 and 50 bar are available from the manufacturer. A test certificate for the setting and a version with NPT thread are available as options.