Safety valve, type-approved, preset and sealed, G 1/2", DN 10, 6.50 bar, brass

For vessels and lines that must stay below their permissible operating pressure at all times, this valve works with a fixed set pressure of 6.50 bar. The corresponding discharge capacity is 302.05 m³/h. The connection is a G 1/2" thread in DN 10 and the body is made of brass.

Benefits

• Connection thread G 1/2" at nominal size DN 10, installation with 27 mm across flats.
• FKM seal, which covers a temperature range from -25 to +180 °C.
• Overall height 75 mm and screw-in section height 14 mm, so the space required can be determined before installation.
• Body material brass, approved for compressed air and other non-toxic, non-flammable gases.
• Type-tested design carrying the component marking TÜV.SV...-882.10.D/G.0.71 CE0036 6,5 bar.

Applications

• Test benches and machines whose system pressure has to be limited to a fixed value.
• Control air circuits that are protected against pressure peaks.
• Manifolds and receivers with a G 1/2" connection.
• Installations with requirements on the resistance of the material brass.

Standards and conformity

The valve is type-tested and carries the component marking TÜV.SV...-882.10.D/G.0.71 CE0036 6.5 bar. Only the factory set and lead-sealed version is supplied, the set value of this article is 6.50 bar. Fixed settings between 0.2 and 50 bar are available from the manufacturer. A test certificate for the setting and a version with NPT thread are available as options.