Reducing fitting, Sealing cone, Nut M30x2 i., Stainless steel - Riegler 112366

Reducing fitting, Sealing cone, Nut M30x2 i., Pipe exterior Ø1 22 mm, Pipe exterior Ø2 18 mm, PN max. 160 bar, Stainless steel Version with parallel thread and soft seal made of NBR. Suitable for compressed air, liquids, natural gas and hydraulics. Not suitable for nitrogen, oxygen, helium, hydrogen or welding gases!

Technical data

Standards and origin

• Customs tariff number: 73072910
• Country of origin: DE

About Reducing fittings

Reducing fittings join two tubes of different outside diameter directly, without an extra adapter piece in between. All 40 items in this group are rated PN 160 to 315 bar and made of 1.4571 stainless steel to DIN 2353.

What matters when choosing

• Tube O.D. 1 and Tube O.D. 2: both sides are specified separately. Go by the tubes actually installed rather than by the nominal size of the valve upstream.
• PN: the range covers 160 to 315 bar. Smaller pairings reach 315 bar while the largest listed combination is rated 160 bar, so the larger side sets the permissible pressure.
• Sealant: FKM and NBR are available. The medium and the line temperature decide which one fits.
• Nut internal thread: it has to match the compression fitting already installed, otherwise existing nuts and cutting rings cannot be reused.
• Material: 1.4571 stainless steel throughout. Where the rest of the line is galvanised steel, plan the material transition at that point deliberately.

Typical applications

• Stepping down from a main pressure line to a thinner control or gauge line inside a hydraulic power unit
• Connecting pressure gauges and pressure switches to existing pipework
• Compressed air installations where the cross section is reduced towards the point of use
• Natural gas lines in industrial plants
• Plant sections under higher corrosion load that require stainless steel throughout

The material is 1.4571 stainless steel to DIN 2353 throughout, sealed with either FKM or NBR. According to the product data these fittings are intended for compressed air, liquids, natural gas and hydraulics, but not for nitrogen, oxygen, helium, hydrogen or welding gases.