Push-in Y-fitting »Blue Series«, rotating, G 1/8 o. - Riegler 109587

Push-in Y-fitting »Blue Series«, rotating, G 1/8 o., for hose exterior Ø 8 mm, pmax short term 15 bar Push-in fittings series manufactured in plastic and nickel-plated brass. All parts are suitable for use with hoses, tubes or pipes made of plastic.

Technical data

Standards and origin

• Customs tariff number: 39174000
• Country of origin: CN

About Male branch Y-fittings

A push-in Y fitting splits a supply line into two outlets right at the threaded port and saves a separate tee plus an extra fitting. Hoses from 4 to 16 mm outside diameter are accepted and the working pressure lies between -0.95 and 10 bar.

What matters when choosing

• Threads are available parallel from M5 and G 1/8 male up to G 1/2 male and taper from R 1/8 to R 1/2 male. Taper threads seal in the thread itself.
• Hose outside diameter of 4 to 16 mm has to match the tubing, and the figure applies to both push-in outlets.
• Working pressure runs from -0.95 bar to 10 bar, with 15 bar listed as a short-term peak.
• The material is plastic or nickel-plated brass, sealed with NBR.
• Rotating versions allow the outlet direction to be set during assembly.

Typical applications

• Feeding two cylinders or two blow nozzles from a single line.
• Distributing compressed air inside jigs where there is no room for a manifold block.
• Connecting vacuum cups down to -0.95 bar.
• Adding a second consumer to an existing port.
• Plumbing handling axes with plastic tubing and plastic pipe.

The fittings are listed for compressed air and are made in plastic or nickel-plated brass with an NBR seal. The 42 articles in this group come from China.