Weld-on nozzle for pressure transducer, G 1, Stainless steel - Riegler 102725

Weld-on nozzles front-flush mounted, for pressure transducer S-11, G 1, Stainless steel 1.4571

Technical data

Standards and origin

• Customs tariff number: 73072910
• Country of origin: DE

About Pressure transmitters

A pressure transducer turns the pressure in the system into an electrical signal that a controller can process. The range covers spans up to 600 bar and comes with process connections from G 1/4 ET to G 1 ET. Both the low pressure and the high pressure side of a plant can therefore be monitored with one series.

What matters when choosing

• Measuring range: the upper limit can be selected between 0 and 600 bar. Working pressure should sit well below it so that pressure peaks do not overrun the sensing cell.
• Thread: G 1/4 ET, G 1/2 ET and G 1 ET as well as G 1/2 IT follow the measuring port already in place.
• Housing material: CrNi steel 1.4571 or CrNi steel 1.4404, decided by the medium and the surroundings.
• Ingress protection: IP 65 to EN 60529 limits mounting to correspondingly protected positions.
• Medium temperature: depending on the type the range lies between -30 °C and 100 °C, which narrows the choice for hot media.

Typical applications

• Pressure monitoring on hydraulic power units
• Reading line pressure in compressed air supply systems
• Pump and compressor control based on an analogue value
• Test rigs that record pressure over time
• Process plant running closed loop pressure control

The transducers are made in Germany, the housing is CrNi steel 1.4571 or 1.4404 and protection is IP 65 to EN 60529. Wetted parts in stainless steel 1.4571 are stated for the types concerned.