Push-in bulkhead L-connector »Blue Series« M14x1, hose ext. Ø 6 - Riegler 109822

Push-in bulkhead L-connector »Blue Series«, M14x1, for hose exterior Ø 6 mm, pmax short term 15 bar Push-in fittings series manufactured in plastic and nickel-plated brass. All parts are suitable for use with hoses, tubes or pipes made of plastic.

Standards and origin

• Customs tariff number: 39174000
• Country of origin: CN

About Bulkhead connectors, elbow type

Push-in bulkhead L-connectors take a compressed air line through a wall or control panel and turn it through 90° behind it. The tube is pushed in without tools and released again via the collet ring. The group covers tube outside diameters from 3 to 16 mm at a working pressure up to 10 bar.

What matters when choosing

• For tube O.D.: 3 to 16 mm. The collet grips the outside diameter of the tube, so this dimension decides, not the clear bore.
• Series: Blue Series or Blue Series mini. The mini range is shorter and is chosen where there is little room behind the wall for the elbow.
• Thread: M8x0.75, M10x1.0 or M12x1.0 male. The panel thread has to suit both the bore and the wall thickness, otherwise not enough thread is left for the lock nut.
• Working pressure: -0.95 bar to 10 bar. The negative figure shows the connector also works under vacuum, for example on suction cups.
• Material and seal: plastic or nickel plated brass with an NBR seal, released for the medium compressed air. Oils and solvents are outside that scope.

Typical applications

• Feeding the compressed air supply through control cabinet and enclosure walls
• Connection panels on machine guards where the tube continues at an angle
• Vacuum lines on handling equipment with suction cups
• Pneumatic controls run in plastic tubing and plastic pipe
• Test and assembly fixtures where lines are plugged and released frequently

All 9 items are made of plastic or nickel plated brass and sealed with NBR. Production is in China.