Corner safety valve, for saturated steam and compressed air, G 2", DN 25, 13.0 bar, gunmetal

Large boilers and vessels need a correspondingly large discharge cross section so that the pressure really falls in a fault case. This corner safety valve with DN 25 and connection G 2" releases 1431 m³/h of compressed air as soon as 13.0 bar is reached. The gunmetal body and the spring steel spring stay dimensionally stable across the range -40 to +150 °C. The overall height is 155 mm.

Advantages

• Gunmetal body, spring steel spring and a seal of EPDM, matched to steam, compressed air and other non-toxic, non-flammable gases.
• Fixed set pressure of 13.0 bar, so the protection is unambiguous without any adjustment on site.
• Corner design with 54 mm face-to-centre length and 155 mm overall height, so the valve adds little to a vessel wall.
• Discharge capacity of 1431 m³/h of compressed air at DN 25, sufficient for the matching receiver or compressor.
• Type tested and marked with the component identification TÜV-SV...-312.25.D/G.0,28 CE0036 13 bar, which simplifies the acceptance of the plant.

Technical data

Applications

Steam boilers to TRD group 1 with a permissible pressure of 13.0 bar. Heat exchangers and steam manifolds with connection G 2". Vessels operated within the temperature range -40 to +150 °C. Plants where the component identification has to be presented for acceptance.

Standards and conformity

The valve is type tested and carries the component identification TÜV-SV...-312.25.D/G.0,28 CE0036 13 bar. It is supplied with a fixed setting only, so the set pressure of 13.0 bar cannot be altered. A setting certificate to 3.1 is available on request. The version is approved for saturated steam and for steam boilers to TRD group 1.