Corner safety valve, for saturated steam and compressed air, G 1/2", DN 10, 10.0 bar, gunmetal

A steam boiler must not exceed its permissible working pressure, not even when the control system fails. This corner safety valve opens at a fixed set pressure of 10.0 bar and releases the excess pressure to atmosphere. The connection is G 1/2" with a nominal size of DN 10. The discharge capacity is 180 m³/h of compressed air. A gunmetal body, a spring steel spring and a seal of EPDM cover the temperature range of -40 to +150 °C.

Advantages

• Connection G 1/2" with nominal size DN 10 and 27 mm across flats, so an ordinary spanner is enough for installation.
• Discharge capacity of 180 m³/h of compressed air at DN 10, sufficient for the matching receiver or compressor.
• Fixed set pressure of 10.0 bar, so the protection is unambiguous without any adjustment on site.
• Temperature range of -40 to +150 °C, which covers outdoor installation and hot media alike.
• Gunmetal body, spring steel spring and a seal of EPDM, matched to steam, compressed air and other non-toxic, non-flammable gases.

Technical data

Applications

Steam boilers to TRD group 1 with a permissible pressure of 10.0 bar. Heat exchangers and steam manifolds with connection G 1/2". Vessels operated within the temperature range -40 to +150 °C. Plants where the component identification has to be presented for acceptance.

Standards and conformity

The valve is type tested and carries the component identification TÜV-SV...-312.10.D/G.0,28 CE0036 10 bar. It is supplied with a fixed setting only, so the set pressure of 10.0 bar cannot be altered. A setting certificate to 3.1 is available on request. The version is approved for saturated steam and for steam boilers to TRD group 1.