Pressure regulator, G 1/2", 0.2 - 6 bar, zinc die casting Z410, inlet pressure max. 25 bar, 70

A steady working pressure saves compressed air and protects the consumers, the pressure regulator provides it. The body is made of zinc die casting Z410. The device is screwed in with G 1/2". The pressure setting range extends over 0.2 - 6 bar. The inlet pressure amounts to at most 25 bar.

Benefits

• Height 146 mm and length 70 mm for installation planning
• Pressure setting range 0.2 - 6 bar as the leading rating of the device
• Connection thread G 1/2" for direct installation in the line
• Inlet pressure at most 25 bar, so the load limit is clearly stated
• Temperature range -10 to +60 °C for use in the workshop and in the plant
• Flow rate 2200 l/min without any appreciable pressure drop in the line

Applications

Assembly lines and manual workstations, pneumatic drives, painting and cleaning technology, laboratory supply.

Standards and conformity

The data sheets refer to Richtlinie 2014/34/EU. Further approvals are not documented and are therefore not stated.