Pivoting bushing, G 3/8 o., for hose I.D. 9 mm - Riegler 111328

Pivoting bushing, ET, cyl. G 3/8 f.hose I.D. 9 nickel-plated brass/brass, working pressure -0.95-15 bar, operating temp.-10°C-70°C

Technical data

Standards and origin

• Customs tariff number: 74122000
• Country of origin: CN

About Swivel hose fittings

A pivoting hose bushing consists of a banjo bolt and a hose tail ring that turns on it, so the hose can still be aligned after the thread has been tightened. That avoids forced bends in tight installations and takes strain off the hose end. Working pressure ranges from -0.95 bar in vacuum up to 15 bar.

What matters when choosing

• Thread: G 1/8, G 1/4 and G 3/8 parallel male. The existing port on the cylinder, valve or manifold decides the size.
• For hose: the tail ring is available for clear bores of 4, 6 and 9 mm. Hose and tail have to match so the clamp bears evenly.
• Working pressure: -0.95 to 15 bar. The negative figure shows that the connection also works under vacuum, not only under positive pressure.
• Material: banjo bolt in nickel-plated brass, tail ring in brass. The pairing keeps the swivel joint moving freely and takes mechanical load.
• Sealing material: PVC, with a temperature range of -10 °C to 70 °C stated in the product text. Hot circuits and media that attack PVC are ruled out.

Typical applications

• Hose connections on tightly installed or moving cylinders
• Vacuum handling with suction cups where the line follows the motion
• Handling equipment with changing hose positions
• Workshop and test setups with frequent reconnection
• Repairs where a rigid port causes the hose to kink at the outlet

The banjo bolt is nickel-plated brass and the tail ring is brass, sealed with PVC. All 6 items come from China.