Pressure regulator, G 3/8", 0.2 - 6 bar, zinc die casting Z410, inlet pressure max. 25 bar

Within the line the pressure regulator has the task of holding the secondary pressure independently of consumption. The connection is made via thread G 3/8". The material used is zinc die casting Z410. The pressure setting range covers 0.2 - 6 bar. The inlet pressure amounts to at most 25 bar.

Benefits

• Flow rate 2200 l/min without any appreciable pressure drop in the line
• Height 146 mm and length 70 mm for installation planning
• Pressure setting range 0.2 - 6 bar as the leading rating of the device
• Connection thread G 3/8" for direct installation in the line
• Inlet pressure at most 25 bar, so the load limit is clearly stated
• Temperature range -10 to +60 °C for use in the workshop and in the plant

Technical data

Applications

Compressed air supply of machines, tools and clamping fixtures, test benches as well as control systems.

Standards and conformity

The data sheets refer to Richtlinie 2014/34/EU. Further approvals are not documented and are therefore not stated.