WLD sensing cable Type B set 2+10 m, 10 m sensing cable with 2 m connecting cable AB, ready to connect - HW group 600920

Spot sensors can hardly protect a liquid-cooled rack row or a raised floor section without gaps. This set monitors 10 m of sensing cable in one piece and connects to a WLD zone input via the 2 m AB connecting cable. According to the manufacturer, the system goes from first drops to alarm in 1-5 minutes.

Benefits

• Detection along the full length: a few drops of conductive liquid anywhere on the 10 m sensing section trigger an alarm.
• Thinner than Type A: the smaller diameter dries faster, and the cable can be cleaned, dried and reused.
• Tolerant installation: no bend radius and no twist limit, stepping on or pressing the cable causes no false alarm, and it can run under door thresholds.
• Mix with Type A: both types share the same 2-pin locking connector and can be combined in one zone.
• Extendable: non-sensing extension cables allow up to 185 m per zone.

Applications

• Raised floors and suspended ceilings in data centers
• Rack rows and cold aisles with cooling units
• Liquid cooling with CDUs and quick disconnects
• Air conditioning, chillers and condensate lines
• Basements and boiler rooms

Compatibility

• Any HW group device with a WLD zone input (green terminal block)
• Can be combined with WLD sensing cable Type A in the same zone
• Extendable with Type B sensing cable without connecting cable, e.g. 600912 and 600913