WLD sensing cable Type A 50 m with connecting cable AB 2 m, total length 52 m, for leak detection - HW group 600468

Large raised-floor areas, long coolant pipe runs or the perimeter of an entire room need a lot of sensing length. With 50 m of sensing cable and a 2 m connecting cable, this package covers such runs in one zone and reports a few drops of water or glycol at any point.

Benefits

• Ready to install: sensing cable plus connecting cable with green terminal block and terminator in one package, 52 m total length.
• Large areas in one zone: 50 m of sensing length, a few drops of water, ethylene glycol or other conductive liquid trigger the alarm.
• Easy to lay without special training: no bend radius, twist or point pressure limits, even when retrofitted among existing cables.
• No false alarms from micro movements of nearby cables, and a disconnected cable is reported as a fault.
• Reusable: after contact with water, clean it, dry it and use it again.
• Can be combined with non-sensing extension cable up to 185 m per zone, or 60 m on NB-WLD.

Applications

• Data centers with large raised-floor areas
• Liquid cooling with CDUs and quick disconnects, long supply and return runs
• Protection against water ingress, cable laid along the room walls
• Storage rooms, archives, plant rooms and timber structures

Compatibility

• WLD2, SD-WLD, Sensor WLD Relay 1W-UNI and Perseus
• NB-WLD with zone length up to 60 m
• J-clips for sensing cable Type A, pack of 10: HW group 600492
• Other packages with connecting cable: HW group 600417 (2+2 m), 600467 (2+10 m)