WLD sensing cable Type B set 2+50 m, 50 m sensing cable with 2 m connecting cable AB, ready to connect - HW group 600921

Protecting a whole server room, an entire floor or a long pipe route against water damage takes a lot of sensing cable with as few joints as possible. This set provides 50 m of Type B sensing cable in one piece plus a 2 m AB connecting cable. According to the manufacturer, the system goes from first drops to alarm in 1-5 minutes.

Benefits

• Detection along the full length: a few drops of conductive liquid anywhere on the 50 m sensing section trigger an alarm.
• Thinner than Type A: the smaller diameter dries faster, and the cable can be cleaned, dried and reused.
• Tolerant installation: no bend radius and no twist limit, stepping on or pressing the cable causes no false alarm, and it can run under door thresholds.
• Mix with Type A: both types share the same 2-pin locking connector and can be combined in one zone.
• Extendable: non-sensing extension cables allow up to 185 m per zone.

Applications

• Large raised floor areas and suspended ceilings in data centers
• Liquid cooling with CDUs and quick disconnects along distribution lines
• Runs along walls to protect whole rooms or floors
• Industrial facilities around pipelines, tanks and production lines
• Warehouses and archives

Compatibility

• Any HW group device with a WLD zone input (green terminal block)
• Can be combined with WLD sensing cable Type A in the same zone
• Extendable with Type B sensing cable without connecting cable, e.g. 600912 and 600913