WLD sensing cable Type A 10 m with connecting cable AB 2 m, total length 12 m, for leak detection - HW group 600467

A row of racks, a coolant pipe run or the cabling under a raised floor can be covered by one zone with 10 m of sensing cable. The package includes the 2 m connecting cable and reports a few drops of water or glycol at any point along the cable.

Benefits

• Ready to install: sensing cable plus connecting cable with green terminal block and terminator in one package, 12 m total length.
• Covers an area: 10 m of sensing length, a few drops of water, ethylene glycol or other conductive liquid trigger the alarm.
• Easy to lay without special training: no bend radius, twist or point pressure limits, even when retrofitted among existing cables.
• No false alarms from micro movements of nearby cables, and a disconnected cable is reported as a fault.
• Reusable: after contact with water, clean it, dry it and use it again.
• Expandable with further sensing cable and non-sensing extension cable up to 185 m per zone (60 m on NB-WLD).

Applications

• Data centers and server rooms, along a rack row under the raised floor
• Liquid cooling with CDUs and quick disconnects, along supply and return lines
• Pipe runs, cable wrapped around the pipe
• Storage rooms, plant rooms and timber structures

Compatibility

• WLD2, NB-WLD, SD-WLD, Sensor WLD Relay 1W-UNI and Perseus
• J-clips for sensing cable Type A, pack of 10: HW group 600492
• Extending a zone with sensing cable A without connecting cable: HW group 600418, 600465, 600466
• Other packages with connecting cable: HW group 600417 (2+2 m), 600468 (2+50 m)