Adjustable 45° connector, tube 12 S, zinc-plated steel, no nut or ring

Once installed, the adjustable 45° connector turns a precision tube through 45 degrees and joins it to a tube stud with a sealing cone and an O-ring. In addition the sheet lists a temperature range of -35 to +100 °C. This version comes with tube stud 12 S and tube connection 12 S (M20x1.5). The version is listed with heavy series and scope of delivery without nut and cutting ring.

Benefits

• The 45 degree turn carries tube 12 S (M20x1,5) on even where a right angle would need too much room.
• The bend can be set to any direction before it is locked and is counter-locked afterwards.
• Sealing cone with an O-ring at tube stud 12 S for a soft joint that can be undone repeatedly.
• Working pressure up to 630 bar in the heavy series.
• Temperature range -35 to +100 °C for the body in zinc-plated steel.

Applications

Where two units are offset from one another the 45 degree bend spans the offset and takes tube 12 S (M20x1,5).

Standards and conformity

The stated temperature range -35 to +100 °C applies to the version in zinc-plated steel. An elastomer seal narrows it.