Adjustable 45° connector, tube 10 L, zinc-plated steel, no nut or ring

In use, the adjustable 45° connector turns a precision tube through 45 degrees and joins it to a tube stud with a sealing cone and an O-ring. It is produced from zinc-plated steel. The data give tube stud 10 L and tube connection 10 L (M16x1.5). In addition the data give light series and scope of delivery without nut and cutting ring.

Benefits

• The 45 degree turn carries tube 10 L (M16x1,5) on even where a right angle would need too much room.
• The bend can be set to any direction before it is locked and is counter-locked afterwards.
• Sealing cone with an O-ring at tube stud 10 L for a soft joint that can be undone repeatedly.
• Working pressure up to 315 bar in the light series.
• Temperature range -35 to +100 °C for the body in zinc-plated steel.

Applications

At a tube stud 10 L in zinc-plated steel the coupling replaces two bends and holds 315 bar.

Standards and conformity

The coupling belongs to the cutting ring system for precision tubes. The tube is cut off square, deburred inside and out and cleaned, and no tube cutter is used.