Adjustable 45° connector, tube 20 S, zinc-plated steel, no nut or ring

The adjustable 45° connector turns a precision tube through 45 degrees and joins it to a tube stud with a sealing cone and an O-ring. It is supplied with tube stud 20 S and tube connection 20 S (M30x2). The article is made of zinc-plated steel. The version is listed with heavy series and scope of delivery without nut and cutting ring.

Benefits

• The 45 degree turn carries tube 20 S (M30x2) on even where a right angle would need too much room.
• The bend can be set to any direction before it is locked and is counter-locked afterwards.
• Sealing cone with an O-ring at tube stud 20 S for a soft joint that can be undone repeatedly.
• Working pressure up to 400 bar in the heavy series.
• Temperature range -35 to +100 °C for the body in zinc-plated steel.

Applications

At a tube stud 20 S in zinc-plated steel the coupling replaces two bends and holds 400 bar.

Standards and conformity

The coupling belongs to the cutting ring system for precision tubes. The tube is cut off square, deburred inside and out and cleaned, and no tube cutter is used.