Adjustable male stud elbow, G 1", tube 25 S, zinc-plated steel

Once installed, the adjustable male stud elbow leads a precision tube out of a parallel G thread at a right angle and holds it with a cutting ring. Material zinc-plated steel is listed for this version. The article is listed with a working pressure of 400 bar. Also stated are heavy series.

Benefits

• The elbow can be set and is then counter-locked, so tube 25 S (M36x2) stays free of stress.
• Parallel male stud thread G 1" with an elastomer seal, so the stud end seals without hemp or adhesive.
• Working pressure up to 400 bar in the heavy series.
• Temperature range -35 to +100 °C, limited by the elastomer seal at the body in zinc-plated steel.
• Tube connection 25 S (M36x2) through a cutting ring, held by both form and friction.

Applications

In power unit construction the tube run in zinc-plated steel stays short because the angle already sits in the coupling and holds 400 bar.

Standards and conformity

The coupling belongs to the cutting ring system for precision tubes. The tube is cut off square, deburred inside and out and cleaned, and no tube cutter is used.