Adjustable male stud elbow, G 1/4", tube 10 L, zinc-plated steel, no nut or ring

In use, the adjustable male stud elbow leads a precision tube out of a parallel G thread at a right angle and holds it with a cutting ring. It is produced from zinc-plated steel. The data give male stud thread G 1/4" and tube connection 10 L (M16x1.5). In addition the data give light series and scope of delivery without nut and cutting ring.

Benefits

• The elbow can be set and is then counter-locked, so tube 10 L (M16x1,5) stays free of stress.
• Parallel male stud thread G 1/4" with an elastomer seal, so the stud end seals without hemp or adhesive.
• Working pressure up to 315 bar in the light series.
• Temperature range -35 to +100 °C, limited by the elastomer seal at the body in zinc-plated steel.
• Tube connection 10 L (M16x1,5) through a cutting ring, held by both form and friction.

Applications

In power unit construction the tube run in zinc-plated steel stays short because the angle already sits in the coupling and holds 315 bar.

Standards and conformity

The coupling belongs to the cutting ring system for precision tubes. The tube is cut off square, deburred inside and out and cleaned, and no tube cutter is used.