Adjustable 45° connector, tube 8 S, zinc-plated steel, no nut or ring

The adjustable 45° connector turns a precision tube through 45 degrees and joins it to a tube stud with a sealing cone and an O-ring. This version is listed with tube stud 8 S and tube connection 8 S (M16x1.5). Its rating is a working pressure of 630 bar. The version is listed with heavy series and scope of delivery without nut and cutting ring.

Benefits

• The 45 degree turn carries tube 8 S (M16x1,5) on even where a right angle would need too much room.
• The bend can be set to any direction before it is locked and is counter-locked afterwards.
• Sealing cone with an O-ring at tube stud 8 S for a soft joint that can be undone repeatedly.
• Working pressure up to 630 bar in the heavy series.
• Temperature range -35 to +100 °C for the body in zinc-plated steel.

Applications

In pipework of the heavy series the bending radius of the tube is left alone because the angle sits in the coupling.

Standards and conformity

Before assembly the stud thread and cone, the inside of the union nut and the cutting ring are oiled. Thin-walled or soft tubes need a reinforcing sleeve.