Adjustable 45° connector, tube 18 L, zinc-plated steel, with sealing cone and O-ring

Once installed, the adjustable 45° connector turns a precision tube through 45 degrees and joins it to a tube stud with a sealing cone and an O-ring. In addition the sheet lists a temperature range of -35 to +100 °C. The stated figure is a working pressure of 315 bar. The version is listed with light series.

Benefits

• The 45 degree turn carries tube 18 L (M26x1,5) on even where a right angle would need too much room.
• The bend can be set to any direction before it is locked and is counter-locked afterwards.
• Sealing cone with an O-ring at tube stud 18 L for a soft joint that can be undone repeatedly.
• Working pressure up to 315 bar in the light series.
• Temperature range -35 to +100 °C for the body in zinc-plated steel.

Applications

At a tube stud 18 L in zinc-plated steel the coupling replaces two bends and holds 315 bar.

Standards and conformity

The coupling belongs to the cutting ring system for precision tubes. The tube is cut off square, deburred inside and out and cleaned, and no tube cutter is used.