Adjustable 45° connector, tube 25 S, stainless steel 1.4571, no nut or ring

This adjustable 45° connector turns a precision tube through 45 degrees and joins it to a tube stud with a sealing cone and an O-ring. The stated material is stainless steel 1.4571. The data sheet gives a working pressure of 400 bar. This version is supplied with heavy series and scope of delivery without nut and cutting ring.

Benefits

• The 45 degree turn carries tube 25 S (M36x2) on even where a right angle would need too much room.
• The bend can be set to any direction before it is locked and is counter-locked afterwards.
• Sealing cone with an O-ring at tube stud 25 S for a soft joint that can be undone repeatedly.
• Working pressure up to 400 bar in the heavy series.
• Temperature range -20 to +200 °C for the body in stainless steel 1.4571.

Applications

Where two units are offset from one another the 45 degree bend spans the offset and takes tube 25 S (M36x2).

Standards and conformity

The stated temperature range -20 to +200 °C applies to the version in stainless steel 1.4571. An elastomer seal narrows it.