Push-in fitting, elbow design, hose bore 6 mm, for pipe and tube

The push-in fitting connects a hose of 6 mm inside diameter and the continuing line. The size is fixed at hose inside diameter 6 mm. The elbow design turns the line by 90 degrees and saves installation length.

Benefits

• With hose inside diameter 6 mm the size is fixed, so no reworking of the line is required
• The change of direction by 90 degrees saves installation length ahead of the port
• The tube is pushed in without tools and released again over the release ring
• The size 6 is clearly assigned and stays available for reordering

Applications

Compressed air installation on machines and plants, pneumatic cylinders and valve terminals, control air lines inside the control cabinet, workshop distribution and service units.