Push-in fitting, Y design, tube 4 mm, second port 4 mm, nickel plated brass

This push-in fitting is designed for a tube of 4 mm outside diameter and a second tube of 4 mm outside diameter. The part accepts the tube without tools and holds it by the gripping claws. The material is nickel plated brass, the size is fixed at tube diameter 4 mm. The Y design splits the line into two outlets.

Benefits

• One part serves two outlets and saves additional joints
• The tube is pushed in without tools and released again over the release ring
• The size 4 is clearly assigned and stays available for reordering
• With tube diameter 4 mm the size is fixed, so no reworking of the line is required

Applications

Water and cooling circuits, pneumatic cylinders and valve terminals, control air lines inside the control cabinet, workshop distribution and service units.

Standards and conformity

Only silicone free seals and lubricants are used during assembly.