Push-in fitting, elbow design, tube 4 mm, stainless steel, for pipe and tube

The push-in fitting accepts a tube of 4 mm outside diameter and the continuing line. The part accepts the tube without tools and holds it by the gripping claws. The material is stainless steel, the size is fixed at tube diameter 4 mm. The elbow design turns the line by 90 degrees and saves installation length.

Benefits

• The tube is pushed in without tools and released again over the release ring
• The size 4 is clearly assigned and stays available for reordering
• With tube diameter 4 mm the size is fixed, so no reworking of the line is required
• The change of direction by 90 degrees saves installation length ahead of the port

Applications

Workshop distribution and service units, compressed air installation on machines and plants, pneumatic cylinders and valve terminals, control air lines inside the control cabinet.

Standards and conformity

The following approvals are documented for the materials used: FDA 21 CFR 177.2600, NSF and ANSI 51 as well as 61.