Angled screw-in supports, R 1/4 o., for hose I.D. 4 mm, PA 6 - Riegler 110973

Angled screw-in supports, R 1/4 o., for hose I.D. 4 mm, AF 14, working pressure max. 10 bar, temperature range -40 to 90 °C, PA 6 Lightweight tube connectors distinguished by high strength, toughness, resistance to abrasion and impact resistance.

Standards and origin

• Customs tariff number: 39174000
• Country of origin: DE

About Male stud elbows

An angled screw-in support is screwed into a female thread and takes a hose on its 90° leg, secured with a hose clamp. It is the lightweight plastic answer wherever a push-in fitting is not required. The group covers hose inside diameters from 4 to 19 mm at a working pressure up to 10 bar.

What matters when choosing

• Thread: R 1/8, R 1/4, R 3/8, R 1/2 or R 3/4 male. The part the support is screwed into sets the size.
• For hose I.D.: 4 to 19 mm. The figure matches the clear bore of the hose, only then does the support sit tight and the clamp seal.
• Pairing of thread and hose bore: not every thread comes in every bore, the samples pair R 1/8 with I.D. 4 to 8 mm and R 3/8 with I.D. 6 to 10 mm.
• Material: polyamide (PA 6). The product text lists high strength, toughness, low weight, abrasion resistance and high impact resistance.
• Working pressure up to 10 bar over a temperature range of -40 to 90 °C. That marks the limit for warm or more heavily loaded circuits.

Typical applications

• Coolant and spray lines on machine tools
• Low pressure air lines in fixtures and at assembly stations
• Venting and breather connections on tanks and enclosures
• Water carrying lines where a metal support would corrode
• Test setups and laboratory installations with frequently changed hoses

All 14 items are made of polyamide (PA 6) and are produced in Germany.