Adjustable T connector with cone, tube 8 S, stainless steel 1.4571, no nut or ring

Once installed, the adjustable T connector splits a line into two paths and joins the tube to a tube stud with a sealing cone and an O-ring. Material stainless steel 1.4571 is listed for this version. The data state a working pressure of 630 bar. Also stated are heavy series and scope of delivery without nut and cutting ring.

Benefits

• The tee branches the line off without needing a second port on the device.
• The branch can be set to any direction before it is locked, so tube 8 S (M16x1,5) stays free of stress.
• Sealing cone with an O-ring at tube stud 8 S for a soft joint that can be undone repeatedly.
• Working pressure up to 630 bar in the heavy series.
• Temperature range -20 to +200 °C for the body in stainless steel 1.4571.

Applications

At tube stud 8 S of a plant of the heavy series the branch sits where a further circuit is to be connected later.

Standards and conformity

Before assembly the stud thread and cone, the inside of the union nut and the cutting ring are oiled. Thin-walled or soft tubes need a reinforcing sleeve.