Adjustable male stud elbow, G 1/2", tube 14 S, zinc-plated steel

This adjustable male stud elbow leads a precision tube out of a parallel G thread at a right angle and holds it with a cutting ring. The article is listed with a working pressure of 630 bar. This version is listed with male stud thread G 1/2" and tube connection 14 S (M22x1.5). The stated material is zinc-plated steel. This version is supplied with heavy series.

Benefits

• The elbow can be set and is then counter-locked, so tube 14 S (M22x1,5) stays free of stress.
• Parallel male stud thread G 1/2" with an elastomer seal, so the stud end seals without hemp or adhesive.
• Working pressure up to 630 bar in the heavy series.
• Temperature range -35 to +100 °C, limited by the elastomer seal at the body in zinc-plated steel.
• Tube connection 14 S (M22x1,5) through a cutting ring, held by both form and friction.

Applications

In power unit construction the tube run in zinc-plated steel stays short because the angle already sits in the coupling and holds 630 bar.

Standards and conformity

The coupling belongs to the cutting ring system for precision tubes. The tube is cut off square, deburred inside and out and cleaned, and no tube cutter is used.