Adjustable male stud elbow, G 3/4", tube 22 L, zinc-plated steel

As a adjustable male stud elbow the article leads a precision tube out of a parallel G thread at a right angle and holds it with a cutting ring. The article is listed with a working pressure of 160 bar. This version is listed with male stud thread G 3/4" and tube connection 22 L (M30x2). Material zinc-plated steel is listed for this version. Also stated are light series.

Benefits

• The elbow can be set and is then counter-locked, so tube 22 L (M30x2) stays free of stress.
• Parallel male stud thread G 3/4" with an elastomer seal, so the stud end seals without hemp or adhesive.
• Working pressure up to 160 bar in the light series.
• Temperature range -35 to +100 °C, limited by the elastomer seal at the body in zinc-plated steel.
• Tube connection 22 L (M30x2) through a cutting ring, held by both form and friction.

Applications

In power unit construction the tube run in zinc-plated steel stays short because the angle already sits in the coupling and holds 160 bar.

Standards and conformity

The coupling belongs to the cutting ring system for precision tubes. The tube is cut off square, deburred inside and out and cleaned, and no tube cutter is used.