Adjustable L connector, tube 25 S, zinc-plated steel, no nut or ring

Once installed, the adjustable L connector turns a precision tube through 90 degrees and joins it to a tube stud with a sealing cone and an O-ring. Material zinc-plated steel is listed for this version. The article is listed with a working pressure of 400 bar. Also stated are heavy series and scope of delivery without nut and cutting ring.

Benefits

• The elbow can be set to any direction before it is locked, so tube 25 S (M36x2) stays free of stress.
• Sealing cone with an O-ring at tube stud 25 S, so the joint seals softly and can be undone repeatedly.
• Working pressure up to 400 bar in the heavy series.
• Temperature range -35 to +100 °C, the limit is set by the O-ring and not by the body in zinc-plated steel.
• Tube connection 25 S (M36x2) through a cutting ring, the tube is held by both form and friction.

Applications

In a control cabinet or power unit in zinc-plated steel the adjustable corner saves the tube bend that would otherwise be needed and holds 400 bar.

Standards and conformity

The coupling belongs to the cutting ring system for precision tubes. The tube is cut off square, deburred inside and out and cleaned, and no tube cutter is used.