Push-in fitting, Y design, hose bore 4 mm, for pipe and tube

The push-in fitting accepts a hose of 4 mm inside diameter and the continuing line. The part accepts the tube without tools and holds it by the gripping claws. The size is fixed at hose inside diameter 4 mm. The Y design splits the line into two outlets.

Benefits

• The size 4 is clearly assigned and stays available for reordering
• With hose inside diameter 4 mm the size is fixed, so no reworking of the line is required
• One part serves two outlets and saves additional joints
• The tube is pushed in without tools and released again over the release ring

Applications

Workshop distribution and service units, compressed air installation on machines and plants, pneumatic cylinders and valve terminals, control air lines inside the control cabinet.