Push-in fitting, Y design, large design, tube 15 mm, POM, for pipe and tube

The material is POM, the size is fixed at tube diameter 15 mm. The push-in fitting connects a tube of 15 mm outside diameter and the continuing line in doing so. The Y design splits the line into two outlets.

Benefits

• The size 15 is clearly assigned and stays available for reordering
• With tube diameter 15 mm the size is fixed, so no reworking of the line is required
• One part serves two outlets and saves additional joints
• Approvals to NSF and ANSI 51 as well as 61, DVGW-W270, KTW are documented for the materials
• The tube is pushed in without tools and released again over the release ring

Technical data

Applications

Compressed air installation on machines and plants, pneumatic cylinders and valve terminals, control air lines inside the control cabinet, workshop distribution and service units.

Standards and conformity

The following approvals are documented for the materials used: NSF and ANSI 51 as well as 61, DVGW-W270, KTW.