Push-in fitting, elbow design, male thread NPT 1/4", tube 6 mm, stainless steel 1.4404

The push-in fitting accepts the male thread NPT 1/4" and a tube of 6 mm outside diameter. The part accepts the tube without tools and holds it by the gripping claws. The operating pressure reaches from -0.95 bar to 15 bar. The elbow design turns the line by 90 degrees and saves installation length.

Benefits

• The temperature range from -20 °C to +150 °C covers cold installation and warm machine surroundings
• The material stainless steel 1.4404 stays resistant without additional coating in the range from -20 °C to +150 °C
• The change of direction by 90 degrees saves installation length ahead of the port
• Approvals to FDA are documented for the materials

Applications

Workshop distribution and service units, compressed air installation on machines and plants, pneumatic cylinders and valve terminals, control air lines inside the control cabinet.

Standards and conformity

The following approvals are documented for the materials used: FDA. Only silicone free seals and lubricants are used during assembly.