Push-in fitting, thread R 3/8", tube 12 mm, polypropylene, FDA compliant, -20 to +80 °C

This push-in fitting is designed for the male thread R 3/8" and a tube of 12 mm outside diameter. The part accepts the tube without tools and holds it by the gripping claws. The material is polypropylene, FDA compliant, the size is fixed at tube diameter 12 mm. The elbow design turns the line by 90 degrees and saves installation length.

Benefits

• With tube diameter 12 mm the size is fixed, so no reworking of the line is required
• The change of direction by 90 degrees saves installation length ahead of the port
• The design stainless steel thread is clearly designated in the data sheet
• Approvals to FDA are documented for the materials
• The tube is pushed in without tools and released again over the release ring

Applications

Compressed air installation on machines and plants, pneumatic cylinders and valve terminals, control air lines inside the control cabinet, workshop distribution and service units.

Standards and conformity

The following approvals are documented for the materials used: FDA.