Push-in fitting, elbow design, male thread G 1/8", tube 4 mm, nickel plated brass

This push-in fitting joins the male thread G 1/8" and a tube of 4 mm outside diameter in one part. The operating pressure reaches from -0.95 bar to 15 bar. The elbow design turns the line by 90 degrees and saves installation length.

Benefits

• The change of direction by 90 degrees saves installation length ahead of the port
• The seal in NBR is matched to the range from -20 °C to +70 °C
• The tube is pushed in without tools and released again over the release ring
• The connection over male thread G 1/8" is fixed in size and needs no adaptor
• With tube diameter 4 mm the size is fixed, so no reworking of the line is required
• The operating pressure from -0.95 bar to 15 bar is released for this size

Applications

Compressed air installation on machines and plants, pneumatic cylinders and valve terminals, control air lines inside the control cabinet, workshop distribution and service units.

Standards and conformity

Only silicone free seals and lubricants are used during assembly.