Push-in fitting, elbow design, male thread M 5, tube 6 mm, nickel plated brass, -0.95 to 20 bar

The push-in fitting accepts the male thread M 5 and a tube of 6 mm outside diameter. The part accepts the tube without tools and holds it by the gripping claws. The material is nickel plated brass, the size is fixed at tube diameter 6 mm. The elbow design turns the line by 90 degrees and saves installation length. The version is fixed with seal NBR.

Benefits

• The tube is pushed in without tools and released again over the release ring
• The size 6 is clearly assigned and stays available for reordering
• The connection over male thread M 5 is fixed in size and needs no adaptor
• With tube diameter 6 mm the size is fixed, so no reworking of the line is required

Applications

Workshop distribution and service units, compressed air installation on machines and plants, water and cooling circuits, pneumatic cylinders and valve terminals.

Standards and conformity

Only silicone free seals and lubricants are used during assembly.