Push-in fitting, elbow design, male thread G 1/4", tube 6 mm, nickel plated brass, standard

The push-in fitting accepts the male thread G 1/4" and a tube of 6 mm outside diameter. The part accepts the tube without tools and holds it by the gripping claws. The temperature range reaches from -20 °C to +80 °C. The elbow design turns the line by 90 degrees and saves installation length. The version is fixed with standard.

Benefits

• Nickel plated brass as material covers the released range from -20 °C to +80 °C
• The change of direction by 90 degrees saves installation length ahead of the port
• The design standard is clearly designated in the data sheet
• The seal in NBR is matched to the range from -20 °C to +80 °C

Technical data

Applications

Compressed air installation on machines and plants, pneumatic cylinders and valve terminals, control air lines inside the control cabinet, workshop distribution and service units.

Standards and conformity

Only silicone free seals and lubricants are used during assembly.