S2V series valve terminal, 8 stations 5/2-way, 25-pin D-sub multipole, G 1/8 side ports - E.MC

At 171 mm overall length, this S2V terminal fits 8 valve stations into a small footprint. It is controlled conventionally through a 25-pin D-sub connector, no bus module required.

Advantages

• Reconfigurable: each station takes a single or double solenoid 5/2-way valve, a 5/3-way valve, a 2x 3/2-way valve or a blanking plate.
• Low heat load in the cabinet at 0.8 W per solenoid, with an LED for every switching state.
• Mounts on a DIN rail or with screws and runs on filtered air without a lubricator.
• One 25-pin D-sub connector for all solenoids, swivelling by 90° for a vertical or horizontal cable exit.
• G 1/8 outlets on the sub-base: hoses stay connected when a valve is replaced.

Applications

• Handling stations and fixtures with eight cylinders supplied from one point.
• Controllers with a digital output card and no fieldbus, where a pre-assembled multipole cable replaces individual wiring.
• Installation in shallow housings or profile frames where hoses are routed out to the side.