Push-in fitting, tee design, large design, tube 32 mm, second port 32 mm, polypropylene

The push-in fitting brings a tube of 32 mm outside diameter and a second tube of 32 mm outside diameter together. The material is polypropylene, the size is fixed at tube diameter 32 mm. The tee design sets a branch at right angles onto the main line.

Benefits

• Approvals to NSF and ANSI 51 as well as 61, DVGW-W270, KTW are documented for the materials
• The tube is pushed in without tools and released again over the release ring
• The size 32 is clearly assigned and stays available for reordering
• With tube diameter 32 mm the size is fixed, so no reworking of the line is required
• One part serves two outlets and saves additional joints

Applications

Control air lines inside the control cabinet, workshop distribution and service units, compressed air installation on machines and plants, pneumatic cylinders and valve terminals.

Standards and conformity

The following approvals are documented for the materials used: NSF and ANSI 51 as well as 61, DVGW-W270, KTW.