Push-in fitting, bulkhead design, bulkhead thread M 20x1, tube 12 mm, stainless steel 1.4404

This push-in fitting joins the bulkhead thread M 20x1 and a tube of 12 mm outside diameter in one part. The operating pressure reaches from -0.95 bar to 15 bar. The bulkhead design leads the line tightly through a panel or wall.

Benefits

• The bulkhead panel may be up to 20 mm thick
• Approvals to FDA are documented for the materials
• The seal in FKM is matched to the range from -20 °C to +150 °C
• The tube is pushed in without tools and released again over the release ring
• The connection over bulkhead thread M 20x1 is fixed in size and needs no adaptor
• With tube diameter 12 mm the size is fixed, so no reworking of the line is required

Technical data

Applications

Pneumatic cylinders and valve terminals, control air lines inside the control cabinet, workshop distribution and service units, compressed air installation on machines and plants.

Standards and conformity

The following approvals are documented for the materials used: FDA. Only silicone free seals and lubricants are used during assembly.