Air supply EB 80, Ø 10 mm, silenced relief, internal pilot air - Riegler 151067

Compressed air supply for valve island EB 80, Ø 10 mm, silenced relief, internal pilot air The EB 80 modules "Compressed Air Supply - P" power the valve base and collect exhaust air from the relief ports. They are available in various versions with different pipe fitting diameters. Pilot air can either be internal or external (recommended). Switching between internal and external pilot air modes is possible by repositioning the orange gasket located between the upper and lower parts of the module. The configuration is indicated by a tab at the rear of the module. Relief ports 3 and 5 can either be connected with a silencer or push-in fitting. A version with separate ports 3 and 5 is also available. This is particularly useful in configurations with external pilot air, allowing the valves to be supplied with different pressures (from vacuum up to 8 bar). A module version without pneumatic connections is also available, specifically designed for configuring a fieldbus island with signal modules only - without any pneumatic section.

Technical data

Standards and origin

• Customs tariff number: 84818099
• Country of origin: IT

About Valve terminals

A valve terminal combines several directional valves, their electrical control and the shared air supply in one assembly. Instead of wiring and tubing every valve separately, one bus cable and one supply line run to the terminal. The valves handle flow rates of 200 to 800 Nl/min at operating pressures up to 10 bar.

What matters when choosing

• Define the function first. Options include 5/2-way monostable, 5/2-way bistable as an impulse valve, 5/3-way with closed centre, and combinations of 3/2-way NC and 3/2-way NO on one slice.
• The connection decides how much wiring is involved. Multipole suits manageable terminals with existing parallel wiring, the version with integrated Profibus DP connects to a fieldbus controller.
• Protection class follows the mounting location. IP 65 for direct mounting on the machine, IP 40 for a protected control cabinet.
• Flow rate from 200 to 800 Nl/min has to match the volume of the connected actuators and the required cycle time.
• Where pressure is controlled rather than only switched, the proportional modules cover a control range of 0.05 to 10 bar at a maximum inlet pressure of 10.5 bar.

Typical applications

• Central valve station for handling and assembly lines with many short cylinder strokes
• Decentralised control mounted on the machine module in IP 65 to shorten tubing runs and switching times
• Packaging and filling lines where grippers, slides and suction cups are coordinated over a fieldbus
• Applications with controlled pressure, for example contact forces set by the proportional modules between 0.05 and 10 bar
• Systems running vacuum and pressure on one terminal using versions with external pilot air

Housings are made from technopolymer, from painted aluminium or from a combination of both, sealed with NBR. The specified medium is filtered, unlubricated compressed air.